Chapter 1: Getting Started
Step 3: Run from the transfer address
Step 3: Run from the transfer address
The transfer address is the entry address defined by the software development tools
and included with the program's symbol information.
• Click on the Run Xfer til () action key.
Or, using the command line, enter:
run from transfer_address until main
Notice the message "Software break: <address>" is displayed on the status line and
that the emulator is "Running in monitor". You may have to click the select mouse
button on the STATUS line to obtain this message. When you run until an address,
a breakpoint is set at the address before the program is run.
Notice the highlighted bar on the screen; it shows the content of the current
program counter.
15