Creating Ipx Sap Filters - Avaya 580 User Manual

CLI Command

Creating IPX SAP Filters

Document No. 10-300077, Issue 2
Table 18-1. IPX SAP Interface Web Page Parameters
Parameter
Aging Interval
Multiplier
Triggered Updates
Get Nearest Server
Reply
Get Nearest Server
Reply Delay(msec.)
Mode
To configure the IPX SAP interfaces using the CLI, enter the following
command from Interface mode:
(config-if <interface-name>)# ipx sap
This section provides the following procedures:
Creating IPX SAP Name Filters
Creating IPX SAP Network Filters
Configuring the IPX SAP Protocol
Allows you to...
Enter the length of time that information from received
SAP updates are kept as a multiplier of the Periodic
Update Interval.Default is 3.
Select one of the following from the pull-down menu:
• Disable – To prevent SAP updates from being
immediately transmitted to the network in
response to changes in the network topology
• Enable – To allow SAP updates to be
immediately transmitted to the network in
response to changes in the network topology
(default).
Select one of the following from the pull-down menu:
• Disable – To prevent the router from responding
to Get Nearest Server requests received on the
interface
• Enable – To allow the router to respond to Get
Nearest Server requests received on the
interface (default).
Specify the delay (in msecs) to wait before responding
to a Get Nearest Service request received on the
interface.Default is 0.
Select one of the following from the pull-down menu:
• Talk/Listen - Send and receive advertisements
(default).
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
2 of 2
18-3