Table of Contents
Advertisement
CLI Commands
Configuring IPX Interfaces
Web Agent
Procedure
Document No. 10-300077, Issue 2
Table 16-2. IPX Routing Global Configuration Web Page Parameters
Parameter
Allows you to...
IPX Routing
Select Disable to prevent IPX from routing globally. The
default value is Enable.
Use Default
Select Enable if you know the default route. The default
Route
value is Disable.
RIP
Select Disable to prevent IPX RIP from routing globally.
This affects all IPX interfaces set up to use the IPX RIP
routing protocol. The default value is Enable.
SAP
Select Disable to prevent IPX SAP from routing globally.
This affects all IPX interfaces set up to use the IPX SAP
routing protocol. The default value is Enable.
Maximum
Enter the maximum number of routes that can be added to
Number of Routes
the routing table. The switch rounds your entry to the
nearest power of 2. For example, if you enter 1000, the
system rounds this number up to 1024 routes. The default
value is 2048.
Maximum
Enter the maximum number of services that can be added.
Number of
The switch rounds your entry to the nearest power of 2. For
Services
example, if you enter 1000, the system rounds this number
up to 1024 services. The default value is 2048.
To enable IPX routing globally using the CLI, enter the following command
from Configure mode:
To enable IPX routing globally, (configure)# ipx routing
To disable IPX routing globally, (configure)# no ipx routing
You can create new IPX interfaces and configure up to four interfaces of
different encapsulation types to a VLAN (multinetting). You can configure
an IPX interface using either the Web Agent or the CLI.
To create a new IPX interface using the Web Agent:
1. In the navigation pane, expand the Routing > IPX > Configuration
folders, and then click Interfaces.
The IPX Interfaces Web page is displayed in the content pane. See
Figure
16-5.
Configuring IPX Routing
16-5
Advertisement
Table of Contents
