Portal Apply Mac-Trigger-Server - HP FlexNetwork 7500 Series Command Reference Manual

Usage guidelines
If the specified maximum number is smaller than the number of current online portal users on the
interface, the limit can be set successfully. The limit does not impact the online portal users. However,
the device does not allow new portal users to log in from the interface until the number drops down
below the limit.
Examples
# Set the maximum number of IPv4 portal users to 100 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname–Vlan-interface100] portal ipv4-max-user 100
Related commands
display portal user
portal max-user

portal apply mac-trigger-server

Use portal apply mac-trigger-server to specify a MAC binding server.
Use undo portal apply mac-trigger-server to restore the default.
Syntax
portal apply mac-trigger-server server-name
undo portal apply mac-trigger-server
Default
No MAC binding server is specified.
Views
Interface view
Predefined user roles
network-admin
mdc-admin
Parameters
server-name: Specifies a MAC binding server by its name, a case-sensitive string of 1 to 32
characters.
Usage guidelines
Only direct portal authentication supports MAC-based quick portal authentication.
For MAC-based quick portal authentication to take effect, perform the following tasks:
•
Configure normal portal authentication.
•
Configure a MAC binding server.
•
Specify the MAC binding server on a portal enabled interface.
Examples
# Specify MAC binding server mts on VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] portal apply mac-trigger-server mts
266