Danfoss VLT Automation VT Drive FC 322 Programming Manual page 37

VLT Automation VT Drive FC322
Programming Guide
0-42 [Auto on] Key on LCP
Option:
[0] Disabled
[1] * Enabled
[2] Password
[3] Hand Off/On
[4] Hand Off/On w. Passw.
0-43 [Reset] Key on LCP
Option:
[0] Disabled
[1] * Enabled
[2] Password
[3] Hand Off/On
[4] Hand Off/On w. Passw.
2.2.7 0-5* Copy / Save
Copy parameter settings between set-ups and to/from the LCP.
0-50 LCP Copy
Option:
[0] * No copy
[1] All to LCP
[2] All from LCP
[3] Size indep. from LCP
This parameter cannot be adjusted while the motor is running.
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Function:
No function
[Auto on] Key is enabled
Avoid unauthorized start in Auto mode. If par. 0-42
Personal Menu, then define the password in par. 0-65
Main Menu Password
the password in par. 0-60
Function:
No function
[Reset] Key is enabled
Avoid unauthorized resetting. If par. 0-43
Menu , then define the password in par. 0-65
Main Menu Password
word in par. 0-60
Function:
No function
Copies all parameters in all set-ups from the frequency converter memory to the LCP memory. For
service purposes it is recommended to copy all parameters to the LCP after commissioning.
Copies all parameters in all set-ups from the LCP memory to the frequency converter memory.
Copies only the parameters that are independent of the motor size. The latter selection can be used
to programme several frequency converters with the same function without disturbing motor data
which are already set.
MG.20.W1.22 - VLT is a registered Danfoss trademark
2 Parameter Description
[Auto on] Key on LCP
is included in the My
Personal Menu Password
.
[Reset] Key on LCP
is included in the par. 0-25
Personal Menu Password . Otherwise define the pass-
.
2
. Otherwise define
My Personal
35