Danfoss VLT Automation VT Drive FC 322 Programming Manual page 22

1 How to Programme
1.1.16 Initialisation to Default Settings
1
Initialise the frequency converter to default settings in two ways:
Recommended initialisation (via par. 14-22
1. Select par. 14-22 Operation Mode
2. Press [OK]
3. Select "Initialisation"
4. Press [OK]
5. Cut off the mains supply and wait until the display turns off.
6. Reconnect the mains supply - the frequency converter is now reset.
7. Change par. 14-22
NB!
Resets parameters selected in Personal Menu with default factory setting.
par. 14-22 Operation Mode
RFI Filter
par. 14-50
par. 8-30 Protocol
par. 8-31 Address
par. 8-32 Baud Rate
par. 8-35 Minimum Response Delay
Max Response Delay
par. 8-36
par. 8-37 Maximum Inter-Char Delay
Operating Hours
par. 15-00
par. 15-20 Historic Log: Event
Alarm Log: Error Code
par. 15-30
Manual initialisation
1. Disconnect from mains and wait until the display turns off.
2a. Press [Status] - [Main Menu] - [OK] at the same time while power up for LCP 102, Graphical Display
2b. Press [Menu] while power up for LCP 101, Numerical Display
3. Release the keys after 5 s.
4. The frequency converter is now programmed according to default settings.
This procedure initializes all except: par. 15-00
NB!
When you carry out manual initialisation, you also reset serial communication, par. 14-50
Removes parameters selected in par. 25-00
NB!
After initialization and power cycling, the display will not show any information until after a couple of minutes.
20
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Operation Mode )
Operation Mode back to Normal Operation
initialises all except:
Over Volt's
to par. 15-05
to par. 15-22 Historic Log: Time
Alarm Log: Time
to par. 15-32
Operating Hours ; par. 15-03
Cascade Controller
MG.20.W1.22 - VLT is a registered Danfoss trademark
.
Power Up's ; par. 15-04 Over Temp's
RFI Filter
.
VLT Automation VT Drive FC322
Programming Guide
; par. 15-05 Over Volt's .
and fault log settings.