Danfoss VLT Automation VT Drive FC 322 Programming Manual page 201

VLT Automation VT Drive FC322
Programming Guide
21-09 PID Auto Tuning
Option:
[0] * Disabled
[1] Enabled Ext CL1 PID
[2] Enabled Ext CL 2 PID
[3] Enabled Ext CL 3 PID
2.18.3 21-1* Closed Loop 1 Ref/Feedback
Configure Extended Closed Loop 1 Controller reference and feedback.
21-10 Ext. 1 Ref./Feedback Unit
Option:
[0] *
[1] * %
[5] PPM
[10] 1/min
[11] RPM
[12] Pulse/s
[20] l/s
[21] l/min
[22] l/h
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Function:
This parameter enables selection of the Extended PID controller to be autotuned and starts the PID
autotuning for that controller. Once the autotuning has successfully completed and the settings have
been accepted or rejected by the user, by pressing [OK] or [Cancel] buttons on the LCP at the end
of tuning, this parameter is reset to [0] Disabled.
Function:
Select the unit for the reference and feedback.
MG.20.W1.22 - VLT is a registered Danfoss trademark
2 Parameter Description
2
199