Danfoss VLT Automation VT Drive FC 322 Programming Manual page 204

2 Parameter Description
21-14 Ext. 1 Feedback Source
Option:
2
[0] * No function
[1] Analog input 53
[2] Analog input 54
[3] Pulse input 29
[4] Pulse input 33
[7] Analog input X30/11
[8] Analog input X30/12
[9] Analog Input X42/1
[10] Analog Input X42/3
[11] Analog Input X42/5
[15] Analog Input X48/2
[100] Bus feedback 1
[101] Bus feedback 2
[102] Bus feedback 3
[200] Ext. Closed Loop 1
[201] Ext. Closed Loop 2
[202] Ext. Closed Loop 3
21-15 Ext. 1 Setpoint
Range:
0.000 Ex- [-999999.999 - 999999.999 Ex-
tPID1Unit* tPID1Unit]
21-17 Ext. 1 Reference [Unit]
Range:
0.000 Ex- [-999999.999 - 999999.999 Ex-
tPID1Unit* tPID1Unit]
21-18 Ext. 1 Feedback [Unit]
Range:
0.000 Ex- [-999999.999 - 999999.999 Ex-
tPID1Unit* tPID1Unit]
21-19 Ext. 1 Output [%]
Range:
0 %* [0 - 100 %]
2.18.4 21-2* Closed Loop 1 PID
Configure the Closed Loop 1 PID controller.
202
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Function:
This parameter defines which input on the frequency converter should be treated as the source of
the feedback signal for the Closed Loop 1 controller. Analog input X30/11 and Analog input X30/12
refer to inputs on the General Purpose I/O .
Function:
The setpoint reference is used in extended 1 closed loop. Ext.1 Setpoint is added to the value from
the Ext.1 Reference source selected in par. 21-13
Function:
Readout of the reference value for the Closed Loop 1 Controller.
Function:
Readout of the feedback value for the Closed Loop 1 Controller.
Function:
Readout of the output value for the Closed Loop 1 Controller.
MG.20.W1.22 - VLT is a registered Danfoss trademark
VLT Automation VT Drive FC322
Programming Guide
Ext. 1 Reference Source .