Table of Contents
Advertisement
VLT Automation VT Drive FC322
Programming Guide
[199]
Pipe Filling
[200]
Full Capacity
[201]
Pump1 Running
[202]
Pump2 Running
[203]
Pump3 Running
Setting in Par. 5-3*
[200] Pump 1 Running
[201] Pump 2 Running
[203] Pump 3 Running
5-30 Terminal 27 Digital Output
Option:
[0] *
No operation
5-31 Terminal 29 Digital Output
Option:
[0] *
No operation
5-32 Term X30/6 Digi Out (MCB 101)
Option:
[0] *
No operation
[1]
Control ready
[2]
Drive ready
[3]
Drive rdy/rem ctrl
[4]
Stand-by / no warning
[5]
Running
[6]
Running / no warning
[8]
Run on ref/no warn
[9]
Alarm
[10]
Alarm or warning
[11]
At torque limit
[12]
Out of current range
[13]
Below current, low
[14]
Above current, high
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Active when the Pipe Fill function is operating. See par. 29-0*.
All pumps running and at full speed
One or more of the pumps controlled by the Cascade Controller are running. The function will also
Fixed Lead Pump
depend on the setting of in
controlled by relay RELAY1 etc. If set to
frequency converter only (without any of the build in relays involved) and Pump 2 to the pump
controlled by the relay RELAY1. See below table:
See [201]
See [201]
Setting in Par. 25-06
[0] No
Controlled by RELAY1
Controlled by RELAY2
Controlled by RELAY3
Function:
Same options and functions as par. 5-3*.
Function:
Same options and functions as par. 5-3*.
Function:
This parameter is active when option module MCB 101 is mounted in the frequency converter.
The control board receives supply voltage.
The frequency converter is ready for operation and applies a supply signal on the control board.
The frequency converter is ready for operation and is in Auto On mode.
Ready for operation. No start or stop command is been given (start/disable). There are no warnings.
Motor is running.
Output speed is higher than the speed set in par. 1-81
motor is running and there are no warnings.
Motor is running within the programmed current and speed ranges set in par. 4-50
Low
Warning Speed High
to par. 4-53
. There are no warnings.
An alarm activates the output. There are no warnings.
An alarm or a warning activates the output.
The torque limit set in par. 4-16
Torque Limit Motor Mode
The motor current is outside the range set in par. 4-18
Motor current is lower than set in par. 4-50
Motor current is higher than set in par. 4-51
MG.20.W1.22 - VLT is a registered Danfoss trademark
2 Parameter Description
No
, par. 25-06. If set to
[0] Pump 1 refers to the pump
Yes
[1] Pump 1 refers to the pump controlled by the
[1] Yes
Frequency Converter controlled
Controlled by RELAY1
Controlled by RELAY2
Min Speed for Function at Stop [RPM]
Warning Current
or par. 1-17 has been exceeded.
Current Limit
.
Warning Current Low
.
Warning Current High
.
2
. The
83
Advertisement
Table of Contents
