Table of Contents
Advertisement
VLT Automation VT Drive FC322
Programming Guide
29-00 Pipe Fill Enable
Option:
[0] *
Disabled
[1]
Enabled
29-01 Pipe Fill Speed [RPM]
Range:
Speed Low
[Speed Low Limit - Speed High Lim-
Limit*
it]
29-02 Pipe Fill Speed [Hz]
Range:
Motor
[Speed Low Limit - Speed High Lim-
Speed Low
it]
Limit*
29-03 Pipe Fill Time
Range:
0 s*
[0 - 3600 s]
29-04 Pipe Fill Rate
Range:
0.001 units/
[0.001 – 999999.999 units/s]
s*
29-05 Filled Setpoint
Range:
0 s*
[0 – 999999,999 s]
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Function:
Select Enabled to fill pipes at a user specified rate.
Select Enabled to fill pipes with a user specified rate.
Function:
Set the filling speed for filling horizontal pipe systems. The speed can be selected in Hz or RPM
depending on the choices made in par. 4-11 / par. 4-13 (RPM) or in par. 4-12 / par. 4-14 (Hz).
Function:
Set the filling speed for filling horizontal pipe systems. The speed can be selected in Hz or RPM
depending on the choices made in par. 4-11 / par. 4-13 (RPM) or in par. 4-12 / par. 4-14 (Hz).
Function:
Set the specified time for pipe filling of horizontal pipe systems.
Function:
Specifies the filling rate in units/second using the PI controller. Filling rate units are feedback units/
second. This function is used for filling-up vertical pipe systems but will be active when the filling-
time has expired, no matter what , until the pipe fill-set-point set in par. 29-05 is reached.
Function:
Specifies the Filled Set-point at which the Pipe Fill Function will be disabled and the PID controller
will take control. This function can be used both for horizontal and vertical pipe systems.
MG.20.W1.22 - VLT is a registered Danfoss trademark
2 Parameter Description
2
265
Advertisement
Table of Contents
