Table of Contents
Advertisement
2 Parameter Description
26-43 Terminal X42/7 Bus Control
Range:
0.00 %*
[0.00 - 100.00 %]
26-44 Terminal X42/7 Timeout Preset
2
Range:
0.00 %*
[0.00 - 100.00 %]
26-50 Terminal X42/9 Output
Option:
[0] *
No operation
[100]
Output freq. 0-100
[101]
Reference Min-Max
[102]
Feedback +-200%
[103]
Motor cur. 0-Imax
[104]
Torque 0-Tlim
[105]
Torque 0-Tnom
[106]
Power 0-Pnom
[107]
Speed 0-HighLim
[108]
Torque +-160%
[109]
Out frq 0-Fmax
[113]
Ext. Closed Loop 1
[114]
Ext. Closed Loop 2
[115]
Ext. Closed Loop 3
[139]
Bus ctrl.
[141]
Bus ctrl t.o.
26-51 Terminal X42/9 Min. Scale
Range:
0.00 %*
[0.00 - 200.00 %]
See principle graph for par. 6-51
260
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Function:
Holds the level of terminal X42/7 if controlled by bus.
Function:
Holds the preset level of terminal X42/7.
In case of a bus timeout and a timeout function is selected in par. 26-50
output will preset to this level.
Function:
Set the function of terminal X42/9.
: 0 - 100 Hz, (0-20 mA)
: Minimum reference - Maximum reference, (0-20 mA)
: -200% to +200% of par. 20-14
: 0 - Inverter Max. Current (par. 16-37
: 0 - Torque limit (par. 4-16
: 0 - Motor rated torque, (0-20 mA)
: 0 - Motor rated power, (0-20 mA)
: 0 - Speed High Limit (par. 4-13
Limit [Hz]
), (0-20 mA)
: 0 - 100%, (0-20 mA)
: 0 - 100%, (0-20 mA)
: 0 - 100%, (0-20 mA)
: 0 - 100%, (0-20 mA)
: 0 - 100%, (0-20 mA)
Function:
Scale the minimum output of the selected analog signal at terminal X42/9, as a percentage of the
maximum signal level. E.g. if a 0 V is desired at 25% of the maximum output value. Then programme
25%. Scaling values up to 100% can never be higher than the corresponding setting in
par. 26-52
Terminal X42/9 Max. Scale
Terminal 42 Output Min Scale
.
MG.20.W1.22 - VLT is a registered Danfoss trademark
VLT Automation VT Drive FC322
Maximum Reference/Feedb.
, (0-20 mA)
Inv. Max. Current
), (0-20 mA)
Torque Limit Motor Mode
), (0-20 mA)
Motor Speed High Limit [RPM]
and par. 4-14
.
Programming Guide
Terminal X42/9 Output
the
Motor Speed High
Advertisement
Table of Contents
