Table of Contents
Advertisement
VLT Automation VT Drive FC322
Programming Guide
23-61 Continuous Bin Data
Range:
0*
[0 - 4294967295 ]
23-62 Timed Bin Data
Range:
0*
[0 - 4294967295 ]
23-63 Timed Period Start
Range:
Application
[Application dependant]
dependent*
NB!
The frequency converter has no back up of the clock function and the set date/time will reset to default (2000-01-01 00:00) after a
power down unless a Real Time Clock module with back up is installed. Consequently the logging will be stopped until date/time is
readjusted in par. 0-70
properly, e.g. after a power down.
NB!
When mounting an Analog I/O MCB109 option card, a battery back up of the date and time is included.
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Function:
Array with 10 elements ([0]-[9] below parameter number in display). Press OK and step between
elements by means of
and
10 counters with the frequency of occurrence for the operating variable monitored, sorted according
to the following intervals:
Counter [0]: 0% - <10%
Counter [1]: 10% - <20%
Counter [2]. 20% - <30%
Counter [3]: 30% - <40%
Counter [4]: 40% - <50%
Counter [5]: 50% - <60%
Counter [6]. 60% - <70%
Counter [7]: 70% - <80%
Counter [8]. 80% - <90%
Counter [9]: 90% - <100% or Max
The above minimum limits for the intervals are the default limits. These can be changed in
Minimum Bin Value
par. 23-65
Starts to count when the frequency converter is powered up for the first time. All counters can be
Reset Continuous Bin Data
reset to 0 in par. 23-66
Function:
Array with 10 elements ([0]-[9] below parameter number in display). Press OK and step between
elements by means of
and
10 counters with the frequency of occurrence for the operating data monitored sorted according to
the intervals as for par. 23-61
Starts to count at the date/time programmed in par. 23-63
time/date programmed in par. 23-64
Reset Timed Bin Data
par. 23-67
Function:
Date and Time
. In par. 0-79
Clock Fault
MG.20.W1.22 - VLT is a registered Danfoss trademark
buttons on the LCP.
.
.
buttons on the LCP.
Continuous Bin Data
.
Timed Period Start
Timed Period Stop
. All counters can be reset to 0 in
.
it is possible to program for a Warning in case clock not has been set
2 Parameter Description
2
, and stops at the
237
Advertisement
Table of Contents
