Table of Contents
Advertisement
VLT Automation VT Drive FC322
Programming Guide
2.6.3 4-5* Adj. Warnings
Define adjustable warning limits for current, speed, reference and feedback.
NB!
Not visible in display, only in VLT Motion Control Tool, MCT 10.
Warnings are shown on display, programmed output or serial bus.
4-50 Warning Current Low
Range:
0.00 A*
[Application dependant]
4-51 Warning Current High
Range:
Application
[Application dependant]
dependent*
4-52 Warning Speed Low
Range:
0 RPM*
[Application dependant]
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20772-Danfoss-131X8135-VLT-Automation-VT-Drive-VFD-FC322-230V-5-HP.aspx
Function:
Enter the I
value. When the motor current falls below this limit (I
LOW
LOW. The signal outputs can be programmed to produce a status signal on terminal 27 or 29 and
on relay output 01 or 02. Refer to the drawing in this section.
Function:
Function:
Enter the n
value. When the motor speed falls below this limit (n
LOW
LOW. The signal outputs can be programmed to produce a status signal on terminal 27 or 29 and
on relay output 01 or 02. Programme the lower signal limit of the motor speed, n
normal working range of the frequency converter. Refer to the drawing in this section.
MG.20.W1.22 - VLT is a registered Danfoss trademark
2 Parameter Description
2
), the display reads CURRENT
LOW
) the display reads SPEED
LOW
, within the
LOW
67
Advertisement
Table of Contents
