Advertisement
After opening the crate, lift the vehicle out from the packing crate, and place the vehicle on a
suitable rack, or using jacks to raise the vehicle for assembling process.
Warning
Torque wrench tightening specifications must be adhered to.
Warning
1. When raising your vehicle make sure to observe the following to reduce the possibility of death or
serious injury.
2. Lift up the vehicle using a floor jack such as the one shown in the illustration.
3. Always use floor jack and ATV jack stands on a solid, flat, level surface.
4. Do not start the engine while the vehicle is supported by floor jack.
5. Do not raise the vehicle while someone is in the vehicle.
6. When raising the vehicle, do not place any objects on top of or underneath the floor jack.
A
A
Assembly
1. Front Shock Absorber
Install the below flange bolt (A) from front
to rear, and then tighten the nut (B) to
450~550 kgf-cm torque.
B
2. Rear Shock Absorber
Take off the bolt (A) from upper mounting
point, and fix the rear shock absorber to the
upper mounting point. Just screw in few
threads by hand. When lower mounting
point are fixed, and then tighten the bolt to
450~550 kgf-cm torque.
12
Hide quick links:
Advertisement
