Disabling Host Route Reception - H3C S3610-28P Operation Manual

Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches
Advertise a summary
route
Note:
You need to disable RIPv2 route automatic summarization before advertising a
summary route on an interface.

2.3.3 Disabling Host Route Reception

Sometimes a router may receive many host routes from the same network, which are
not helpful for routing and occupy a large amount of network resources. In this case,
you can disable RIP from receiving host routes to save network resources.
Follow these steps to disable RIP from receiving host routes:
Enter system view
Enter RIP view
Disable RIP from
receiving host routes
Note:
RIPv2 can be disabled from receiving host routes, but RIPv1 cannot.
2.3.4 Advertising a Default Route
You can configure RIP to advertise a default route with A specified metric to RIP
neighbors.
Follow these steps to configure RIP to advertise a default route:
Enter system view
Enter RIP view
To do...
rip summary-address
ip-address { mask | mask-length }
To do...
To do...
system-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
Use the command...
Use the command...
System-view
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
undo host-route
Use the command...
2-10
Chapter 2 RIP Configuration
Remarks
Required
Remarks
—
—
Required
Enabled by default
Remarks
––
––