Configuring A Priority For Rip; Configuring Rip Network Optimization - H3C S3610-28P Operation Manual

Operation Manual – IPv4 Routing
H3C S3610&S5510 Series Ethernet Switches

2.3.6 Configuring a Priority for RIP

Multiple IGP protocols may run in a router. If you want RIP routes to have a higher
priority than those learned by other routing protocols, you can assign RIP a smaller
priority value to influence optimal route selection.
Follow these steps to configure a priority for RIP:
To do...
Enter system view
Enter RIP view
Configure a priority for
RIP
2.3.7 Configuring RIP Route Redistribution
Follow these steps to configure RIP route redistribution:
To do...
Enter system view
Enter RIP view
Configure a default
metric for redistributed
routes
Redistribute routes
from another protocol

2.4 Configuring RIP Network Optimization

Complete the following tasks before configuring RIP network optimization:
Configure network addresses for interfaces, and make neighboring nodes
reachable to each other;
Configure RIP basic functions.
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
preference [ route-policy
route-policy-name ] value
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
default-cost value
import-route protocol
[ process-id ] [ allow-ibgp ]
[ cost cost | route-policy
route-policy-name | tag tag ] *
2-12
Chapter 2 RIP Configuration
Remarks
––
––
Optional
100 by default
Remarks
––
––
Optional
The default metric of a
redistributed route is 0
by default.
Required
No redistribution is
configured by default.