Omron SYSMAC CS Series Operation Manual page 735

Specifications of Basic I/O Units and High-density I/O Units
High-density I/O Unit Limitations
Limitations on the switching capacity of C200H-OD215/MD115/MD215 Transistor Output Units and the usable
number of I/O points in the C200H-ID215 and C200H-MD215 are shown below.
Switching Capacity
The switching capacity of C200H-OD215/MD115/MD215 Transistor Output Units depends on the power supply
voltage, as shown below.
C200H-MD501 TTL I/O Unit
Used for 16 Static Inputs and 16 Static Outputs
Output Specifications (Connector 1)
Input Specifications (Connector 2)
100
50
16
0
0 4.5
Power Supply Voltage (V)
Max. Switching Capacity
Leakage Current
Residual Voltage
ON Response Time
OFF Response Time
No. of Circuits
Fuses
Power for External Supply
Rated Input Voltage
Input Impedance
Input Current
ON Voltage
OFF Voltage
ON Response Time
OFF Response Time
No. of Circuits
High-speed Inputs
10 20.4 26.4
5 V DC±10% 35 mA (280 mA/common, 560 mA/
Unit; output resistance 4.7 kΩ)
0.1 mA max.
0.4 V max.
0.2 ms max.
0.3 ms max.
2 (8 points/common)
2 (1 fuse/common; fuses are not user-replaceable.)
20 mA 5 V DC±10% min. (1.2 mA × no. of outputs
ON)
5 V DC±10%
1.1 kΩ
3.5 mA typical (at 5 V DC)
3.0 V DC min.
1.0 V DC max.
2.5 ms/15 ms max. (switchable)
2.5 ms/15 ms max. (switchable)
2 (8 points/common)
8 points (connector 2 terminals 8 to 15, when set)
Pulse width: 1 ms/4 ms min. (switchable)
Appendix A
697