Omron SYSMAC CS Series Operation Manual page 387

PLC Setup
Schedule Interrupt Interval
Programming
Console address
Word Bit(s)
+195 0 to 3 0 hex: 10 ms
1 hex: 1.0 ms
Default: 0 hex
Power OFF Detection Time (Power OFF Detection Delay Time)
Programming
Console address
Word Bit(s)
+225 0 to 7 00 to 0A:
0 to 10 ms
(1-ms units)
Default: 00
Power OFF Interrupt Disable
Programming
Console address
Word Bit(s)
+225 15 0: Disabled
1: Enabled
Default: 0
Settings
Sets the time interval for the scheduled
interrupt task.
Settings
This setting determines how much of a
delay there will be from the detection of a
power interruption (approximately 10 to
25 ms after the AC power supply voltage
drops below 85% of the rated value or DC
power supply voltage drops below 80% of
the rated value) to the confirmation of a
power interruption. The default setting is 0
ms.
When the power OFF interrupt task is
enabled, it will be executed when the power
interruption is confirmed. If the power OFF
interrupt task is disabled, the CPU will be
reset and operation will be stopped.
Settings
When this setting is set to 1, the power OFF
interrupt task will be executed when power
is interrupted.
Function
Function
Function
Section 7-1
Related New
flags and setting's
words effective-
ness
--- Takes effect
at the start of
operation.
(Can't be
changed dur-
ing opera-
tion.)
Related New
flags and setting's
words effective-
ness
--- Takes effect
at startup or
at the start of
operation.
(Can't be
changed dur-
ing opera-
tion.)
Related New set-
flags and ting's
words effective-
ness
--- Takes effect
at startup or
at the start of
operation.
(Can't be
changed dur-
ing opera-
tion.)
349