Omron SYSMAC CS Series Operation Manual page 337

Installation
DIN Track
DIN Track Installation
1,2,3...
DIN Track Mounting
Bracket
The following DIN Tracks are available.
Model
PFP-50N 50 cm long, 7.3 mm high
PFP-100N 1 m long, 7.3 mm high
PFP-100N2 1 m long, 16 mm high
1. Attach Mounting Brackets to each side (left and right) of the Backplane as
shown below.
There are two Backplane mounting screws each on the left
and right sides of the Backplane. Use these screws to attach
the DIN Track Mounting Brackets to the Backplane.
(Tighten to a torque of 0.9 N·m.)
2. Mount the Backplane to the DIN Track so that the hooks on the Mounting
Brackets fit into the upper portion of the DIN Track as shown below.
Backplane
Specification
Backplane (rear view)
These hooks fit into the DIN Track
DIN Track Mounting Bracket
Section 5-2
DIN Track
299