Omron SYSMAC CS Series Operation Manual page 335

Programmable controllers

Hide thumbs Also See for SYSMAC CS Series:

Table of Contents

Installation

1. Mount the Unit to the Backplane by hooking the top of the Unit into the slot

on the Backplane and rotating the I/O Unit downwards. (Groups A and B)

2. Make sure that the connector on the back of the Unit is properly inserted

into the connector in the Backplane. (Groups A and B)

3. With the Group-A Units, use a Phillips-head screwdriver to tighten the

screw on the bottom of Unit. The screwdriver must be held at a slight angle,

so be sure to leave enough space below each Rack.

Note The screws at the bottoms of the Units must be tightened to the fol-

lowing torques.

Power Supply Unit: 0.9 N·m

With Group-B Units, the lock lever will snap into place when the Unit is

properly inserted. Check that the lock lever is engaged and the Unit is se-

Chapters

Table of Contents

Cs1g/h-cpu_h Cs1g/h-cpu_-ev1