Automatic Transfers At Power On Without A Parameter File - Omron SYSMAC CS Series Operation Manual

CS1-H CPU Unit Ver. 2.0 Upgrades
CPU Unit Ver. 2.0 or Later and CX-Programmer Ver. 4.0 or Higher
Summary
1-6-8

Automatic Transfers at Power ON without a Parameter File

Previous CPU Units (Pre-Ver. 2.0 CPU Units)
When using CX-Programmer Ver.4.0 or higher with CPU Unit Ver. 2.0 or later,
the first address can be set for up to 64 slots.
Note This function is supported only for CS1-H, CJ1-H, and CJ1M CPU Units
Ver. 2.0 or later. It is not supported for CS1D CPU Units.
CX-Programmer
Ver. 4.0 or higher
CPU Unit Ver. 2.0
or later
CPU Rack slot
Rack 1 slot
Rack 2 slot
Rack 7 slot
Previously with the CS/CJ-series CPU Units, both the program file for auto-
matic transfer at power ON (AUTOEXEC.OBJ) and the parameter file for auto-
matic transfer at power ON (AUTOEXEC.STD) had to be stored on the
Memory Card to enable automatic transfers to the CPU Unit at power ON.
Also, the parameter file for automatic transfer at power ON (AUTOEXEC.STD)
could not be created without the actual PLC (regardless of whether it was
made in online operations from the CX-Programmer or a Programming Con-
sole or by using the easy backup operation).
First slot addresses
Example:
Rack No. Slot No.
CPU Rack Slot No. 00
CPU Rack Slot No. 02
Rack 1 Slot No. 00
Rack 1 Slot No. 02
Rack 2 Slot No. 00
Rack 2 Slot No. 01
Rack 7 Slot No. 01
CIO 0100
0 1 2
CIO 0000
CIO 0102
2
0 1 3 4
CIO 0001
CIO 0105
0 1 2
CIO 0005
CIO 0155
0 1 2
CIO 0050
Section 1-6
100
0
Up to 64 settings
102
can be made.
1
105
5
50
49