Servicing The Sp Card (Fru) - Oracle X5-4 Service Manual

d. Then, slide the divider downward to lock the tabs in the slots and secure it
against the wall.
To ensure proper alignment of the Fault Remind switch, both tabs must be engaged with
their slots.
17. Reconnect the SAS and any NVMe cables to the disk backplane.
See "Replace the SAS 12 Gb/s Internal HBA SAS Cables (FRU)" on page 204
the NVMe Switch Card Cables (FRU)" on page
Reconnect the ESM cable to the ESM.
18.
See "Replace the SAS 12 Gb/s Internal HBA ESM Cable (FRU)" on page
Or, if you removed the ESM, reattach it to the dual lock strip on the chassis.
19. Install all disk drives and filler panels.
See "Install a Storage Drive (CRU)" on page
20. Install the DVD drive.
See "Install the DVD Drive or DVD Drive Filler Panel" on page
Prepare the server for operation.
21.
See "Prepare the Server for Operation" on page
Note -
need to be reprogrammed by authorized service personnel with the correct product serial
number.

Servicing the SP Card (FRU)

This section provices procedures for removing and installing the motherboard-mounted service
processor (SP) card.
The replaceable SP card contains the embedded server management software, Oracle ILOM.
"Remove the SP Card (FRU)" on page 244
■
"Install the SP Card (FRU)" on page 245
■
The product serial number used for service entitlement and warranty coverage might
215.
118.
170.
259.
Servicing FRU Components
Servicing the SP Card (FRU)
and "Replace
209.
243