Oracle X5-4 Service Manual page 218

Replace the NVMe Switch Card Cables (FRU)
4. Disconnect the four NVMe cables (0 through 3) from the disk backplane board.
5. Remove the NVMe cables from the air divider, as follows.
a. Detach the NVMe, HBA, and ESM cables from the three cable clips on the
memory riser side of the air divider. Then, carefully lift the cables up and
out of the cable slot [B] in the air divider that provides access to the disk
backplane area.
218 Oracle Server X5-4 Service Manual • December 2015