Caution -
removing or installing the DVD drive. You must disconnect the power cables before performing
this procedure.
This procedure describes how to remove the DVD drive or a DVD drive filler panel.
For serviceability considerations, see
Before You Begin
■
1.
Prepare for service.
See
"Prepare the Server for Cold Service" on page
To replace the DVD drive, the server must be disconnected from the power source.
2.
At the front of the server, push down on the latch on the top left corner of the
DVD drive or filler panel.
Component damage. Ensure that all power is removed from the server before
Remove the DVD Drive or DVD Drive Filler Panel
"Component Serviceability" on page
94.
Servicing CRU Components
70.
169