Table of Contents
Advertisement
The levers rise as the DIMM is pushed further into the slot.
4.
Ensure that the levers have risen completely and have locked the DIMM in the
slot.
5.
Repeat the above steps until all replacement DIMMs are installed.
Component damage. Ensure that all levers are closed and locked. Open DIMM
Caution -
ejector levers can break off during the installation of the memory riser (MR) card. All populated
and unpopulated DIMM slot ejector levers on the MR card must be in the fully-closed position
before installing the card in the server.
"Install a Memory Riser Card" on page 152
Next Steps
Install a DIMM
Servicing CRU Components
151
Advertisement
Table of Contents
Troubleshooting
