Storage Subsystem - Oracle X5-4 Service Manual

Server Subsystems Overview
reset might be required after a software or firmware update or when you want to launch Oracle
System Assistant or the BIOS Setup Utility.
Cold Reset
A cold reset occurs when you restart the server from a completely powered-off state. A cold
reset might be required to resolve a system issue. To perform a cold reset, place the server in
standby power mode, disconnect the server from its AC power source, wait 30-60 seconds, then
reconnect the server to its AC power source, allow the SP to boot, and then reapply full power.
See Also:
"Power On the Server" on page 271
■
"Powering Off the server" on page
■
"Resetting the Host or Service Processor" on page
■

Storage Subsystem

The server storage subsystem consists of the following:
"Six 2.5-inch Drive Bays" on page 30
■
"SATA DVD +/-RW Drive" on page 31
■
Six 2.5-inch Drive Bays
The six 2.5-inch storage drive bays are located at the front of the server. The supported drive
interfaces for each bay depend on the type of storage controller installed at the factory. SAS
drives require a SAS Host Bus Adapter (HBA) and NVMe drives require a PCIe NVMe Switch
card.
30 Oracle Server X5-4 Service Manual • December 2015
101.
63.