Install A Storage Drive Filler Panel (Cru); Storage Drive Reference - Oracle X5-4 Service Manual

4. Close the latch to lock the drive in place.
5. Do one of the following:
If you have replaced an NVMe drive using a hot-service procedure, refer to
■
the following for powering on the device:
"Removing and Replacing an NVMe Storage Drive Using Oracle
■
Solaris" on page 121
"Removing and Replacing an NVMe Storage Drive Using Oracle
■
Linux" on page 125
If you have replaced a storage drive using a cold-service procedure, power
■
on the server and configure the storage drive.
Use one of the power options described in
6. Perform administrative tasks to reconfigure the drive.
The procedures that you perform at this point depend on how your data is configured. You
might need to partition the drive, create file systems, load data from backups, or have the drive
updated from a RAID configuration.
"Storage Drive Reference" on page 119
See Also ■

Install a Storage Drive Filler Panel (CRU)

For information about component filler panels, see
1. Verify that the release lever on the storage drive filler panel is fully opened.
To open the lever, push the release button on the front of the filler panel.
Slide the storage drive filler panel into the drive slot until it is fully seated.
2.
3. Close the latch to lock the filler panel in place.
"Storage Drive Reference" on page 119
See Also ■

Storage Drive Reference

This section shows the location and explains the functions of the storage drive status indicators.

Install a Storage Drive Filler Panel (CRU)

"Power On the Server" on page
"Component Filler Panels" on page
Servicing CRU Components
271.
81.
119