Remove A Pcie Card - Oracle X5-4 Service Manual

Remove a PCIe Card

When servicing the components in this section, unplug the AC power cords and use ESD
protection.
Caution -
removing or installing expansion cards. You must disconnect the power cables before
performing this procedure.
For serviceability considerations, see
Before You Begin ■
For PCIe slot designation information, see
■
1. Prepare for service.
See "Prepare the Server for Cold Service" on page
Locate the PCIe card that you want to remove.
2.
See "Server Back Panel Features" on page 18
locations.
3. If are replacing a PCIe card with a card of the same type, make a note of where
the PCIe card is installed.
A list of supported PCIe cards and their population order is listed in the Product Notes for the
server.
4. Unplug all data cables from the PCIe card.
Make note of the cables, so you can install them in the same connectors on the replacement
card.
Component damage. Ensure that all power is removed from the server before
"Component Serviceability" on page
"Component Designations" on page
94.
for information about PCIe slots and their
Servicing CRU Components
Remove a PCIe Card
70.
73.
161