Troubleshooting Hardware Faults Using Oracle ILOM
Indicator Blink Rates
Note -
example, blade or rack mount).
This section describes the following indicator blink rates:
"Steady On" on page 46
■
"Steady Off" on page 47
■
"Slow Blink Rate" on page 47
■
"Fast Blink Rate" on page 48
■
"Single (Standby) Blink Rate" on page 48
■
"Slow Unison Blink Rate" on page 49
■
"Insertion Blink" on page 49
■
"Unison Steady On" on page 49
■
"Alternating (Invalid FRU) Blink Rate" on page 50
■
"Feedback Flash" on page 51
■
"Data Blink Rate" on page 51
■
"Sequential (Diagnostic) Blink Rate" on page 51
■
Steady On
For the steady on state, an indicator is continually on (lit) and does not blink. This indicates a
continuing condition, for example, an operational state (green) or a Service Action Required
fault state (amber).
46
Oracle Server X5-4 Service Manual • December 2015
The blink rate information described here might not apply to all server types (for