Install A Storage Drive (Cru) - Oracle X5-4 Service Manual

Install a Storage Drive (CRU)

Install a Storage Drive (CRU)

Installing a storage drive into a server is a two-step process. You must first install the storage
drive into the drive slot, and then configure that drive to the server.
Note -
replacement drive in the same slot as the drive that was removed. Storage drives are physically
addressed according to the slot in which they are installed.
For serviceability considerations, see
Before You Begin ■
For storage drive designation information, see
■
Designations" on page
1. Prepare the server:
For hot service, see
■
For cold service, see
■
2. Verify that the release lever on the storage drive is fully opened.
Slide the drive into the drive slot until it is fully seated.
3.
118 Oracle Server X5-4 Service Manual • December 2015
If you removed an existing storage drive from a slot in the server, you must install the
78.
"Prepare the Server for Hot Service" on page
"Prepare the Server for Cold Service" on page
"Component Serviceability" on page
"DVD, Storage Drive, and USB
70.
93.
94.