Table of Contents
Advertisement
Chapter 3 Setup
Set the network
You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's
product.
Configurator, check "Driver / Utility" on the download
page
at
Mimaki
download/).
1
Press the
2
Press
and press the
3
Press the
4
Press
and press the
5
Press
and press the
6
Press
Address" and press the
• The IP address currently used by this machine is
displayed.
• After connecting with the network, it takes time
until the IP address is determined.
If the IP address has not been determined,
"0.0.0.0" is displayed.
7
Press
Address", and press the
• The MAC address currently used by this machine
is displayed.
8
Press
press the
• Press [][] to set ON/ OFF.
• When it is ON, the IP address given by the DHCP
server is used.
9
Press
press the
• Press """" to set ON/ OFF.
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press
and press the
• Both of DHCP and AutoIP is OFF, you can set IP
Address/ Default Gateway/ DNS Address/ Sub
Net Mask. For other than above, proceed to the
Step 13.
11
Press
values.
3-22
To
download
the
Network
Engineering
(http://mimaki.com/
(MENU) in Local.
to select machine setup,
key.
(>>) twice.
to select "Network & Mail",
key.
to select "Network & Mail",
key.
to select "Check MAC
key.
to select "Check MAC
key.
to select "DHCP", and
key.
to select "AutoIP", and
key.
to select the next items,
key.
to select the set
12
Press
key to confirm the value.
13
Press
the setting.
• To reflect network setting, once turn off the power
supply and then turn it on again.
Setting event mail function
Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to
an error.
You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's
product.
To
Configurator, check "Driver / Utility" on the download
page
at
Mimaki
Engineering
download/).
Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.
Enable the event mail function
1
Press the
2
Press
to select machine setup,
and press the
3
Press the
4
Press
to select "Network & Mail",
and press the
5
Press
to select "Event Mail" and
press the
6
Press
to select "Mail Delivery",
and press the
7
Press
to select "ON" and press
the
key.
8
Press
the setting.
key several times to end
download
the
Network
(http://mimaki.com/
(MENU) in Local.
key.
(>>) twice.
key.
key.
key.
key several times to end
Advertisement
Table of Contents
