Setting The Display Of Media Detection; Setting The Confirm. Feed; Set The Network - MIMAKI UJV55-320 Operation Manual

Setting the Display of Media Detec-
tion
Set the following two items in media detection settings.
When loading the media, set whether
Setting of Media to detect the media width automatically
Detection (AUTO) or decide the print range
manually (MANUAL).
• When using the media that cannot be detected by
the sensor, set the media detection setting to
"MANUAL".
• When "MANUAL" is selected, the values of
"MARGIN (RIGHT/LEFT)" on the SETUP MENU
have no effect. (
1
Press the
2
Press
and press the
3
Press the
4
Press
and press the
5
Press
and press the
6
Press the
end the setting.

Setting the CONFIRM. FEED

Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
Press the
2
Press
and press the
3
Press the
4
Press
FEED" , and press the
5
Press
press the
• Set value : ON/ OFF
6
Press the
end the setting.
3-16
P.3-8)
(MENU) in Local.
to select "Machine Setup",
key.
(>>) .
to select "Media Detect",
key.
to select AUTO/MANUAL,
key.
key several times to
(MENU) in Local.
to select "Machine Setup",
key.
(>>) .
to select "CONFIRM.
key.
to select a set value, and
key.
key several times to

Set the network

You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at
Mimaki Engineering (http://eng.mimaki.co.jp/download/).
1
Press the
2
Press to select "Machine Setup"
and press the
3
Press the
4
Press to select "Network & Mail"
and press the
5
Press to select "Network" and
press the
6
Press to select "Check IP
Address" and press the
• The IP address currently used by this machine is
displayed.
• After connecting with the network, it takes time
until the IP address is determined.
If the IP address has not been determined,
"0.0.0.0" is displayed.
7
Press to select "Check MAC
Address" and press the
• The MAC address currently used by this machine
is displayed.
8
Press to select "DHCP" and
press the
• Press [][] to set ON/ OFF.
• When it is ON, the IP address given by the DHCP
server is used.
9
Press to select "AutoIP" and
press the
• Press """" to set ON/ OFF.
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press to select the set values
and press the
• Both of DHCP and AutoIP is OFF, you can set IP
Address/ Default Gateway/ DNS Address/ Sub
Net Mask. For other than above, proceed to the
Step 13.
(MENU) in Local.
key.
(<<) .
key.
key.
key.
key.
key.
key.
key.