Table of Contents
Advertisement
Message
ERROR 44d
STATION POS ERR
ERROR 453
Take-UP Direction
ERROR 468
Feed MTR ERR
ERROR 469
Take MTR ERR
ERROR 505
MEDIA JAM
ERROR 50a
Y ORIGIN
ERROR 50c
MEDIA WIDTH SENSOR
ERROR 50f
L-SCALE BLACK
ERROR 516
MEDIA SET POSITION R
ERROR 516
MEDIA SET POSITION L
ERROR 531
INK TNK SENS
:12345678
ERROR 539
Calibration
:12345678
ERROR 53a
Flushing BOX Flushing [Z]
ERROR 53b
Flushing BOX Origin [Y]
ERROR 607
CAP CLEANING
Cause
An abnormality occurred in the station
position.
The take-up direction of the media that has
been set in the media take-up device is not
made to the specifications recommended
(face-out winding).
An abnormality occurred in the feeding
motor.
An abnormality occurred in the take-up
motor.
A media jam is occurred.
Y-origin could not be detected.
The media width has not been detected
correctly.
Abnormal linear scale.
The media is set outside the proper area.
Abnormality has occurred in the balance of
the ink supply unit.
Abnormality has occurred in the data of the
weight balance of the ink supply unit.
Failed to detect the origin for the flushing
BOX.
The flushing BOX is not set in the correct
position.
Time to clean the cap
Chapter 5 Troubleshooting
Measures
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Please make the face-in winding direction
of the media.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Remove the jammed media, please re-
set the media.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Check the media set position.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Check the media set position.
• Please make sure that the weight is set
correctly to the ink tank, do not apply
shocks, and do not place heavy objects
on the ink tank..
• Please execute the "Tank Calibration
(P.4-28)".
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Please execute the "Tank Calibration
(P.4-28)".
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
• Set the flushing BOX is in the correct
position, and fasten the clasp.
• Perform the station maintenance, and
clean the cap.
1
2
2
2
5
5-15
Advertisement
Table of Contents
