Setting The Confirm. Feed; Setting The Space Feed Mode; Set The Network - MIMAKI JV150-130 Operation Manual

Setting the CONFIRM. FEED

Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
Press the
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press the
3
Press
FEED", and press the
4
Press
press the
• Set value : ON/ OFF
5
Press the
to end the setting.

Setting the SPACE FEED MODE

Change the feed mode of the margin included in the
image data (the space of no data to be printed). If print
data with much margin, set to "continuous", then the print
time can be shorten.
1
Press the
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press the
3
Press
MODE" , and press the
4
Press
press the
INTERMITTENT：Perform
operation of the path division unit
CONTINUOUS ：Feed the no data part at a time
5
Press the
to end the setting.
(MENU) (twice)
(<<) .
to select "CONFIRM.
key.
to select a set value, and
key.
key several times
(MENU) (twice)
(<<) .
to select "SPACE FEED
key.
to select a set value, and
key.
intermittent feed
key several times
Chapter 3 Mchine setting

Set the network

You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://eng.mimaki.co.jp/download/).
1
Press the
times)
• MACHINE SETUP MENU will be displayed.
2
Press the
3
Press
and press the
4
Press the
• "CHECK IP ADDRESS" will be selected.
• The IP address currently used by this machine is
displayed.
• When you have finished the check, press the
[ENTER] key.
• After connecting with the network, it takes time until
the IP address is determined. If the IP address has
not been determined, "0.0.0.0" is displayed.
5
Press , and press the
• "CHECK MAC ADDRESS" will be selected.
• The MAC address currently used by this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
6
Press , and press the
• "DHCP" will be selected.
7
Press
press the
• Set value : ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
8
Press , and press the
• "AutoIP" will be selected.
9
Press
press the
• Set value : ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press , and press the
• "IP ADDRESS" will be selected.
11
Press
press the
• Set value : ON/ OFF
• Both of DHCP and AutoIP is OFF, you can set IP
Address. For other than above, proceed to the
Step 14.
(MENU) (twice
key in LOCAL.
(<<) .
to select "NETWORK",
key.
key.
key.
key.
to select a set value, and
key.
key.
to select a set value, and
key.
key.
to select a set value, and
key.
1
2
3
4
5
6
3-17