Table of Contents
Advertisement
Chapter 2 Basic Operation
Preparation to install Take-up tension
bar weight
In case of using Tension bar by
making it heavy
Stack the ring parts of CW wire both ends and hitch the
hook.
In case of using Tension bar by
making it light
1
Remove the wire guide cover.
Screw
Wire guide cover
2
Hitch the wire to two pulleys.
Wire
3
Stack the ring parts of CW wire both ends
and hitch the hook.
Hook
2-18
Hook
Ring part
フック
Pulleys
リング部
Ring part
4
Hitch the hook of the weight to the rings of
CW wire both ends.
Hook
Changing the printing origin
The position of the printing origin can be changed.
1
In Local, Press
• It enters into the origin setting mode.
2
Press
temperature of heater.
• Select the carriage and media, moving the point
with [][][][].
• When you press [FUNC2](CUT) here, you can
perform media cutting.
Set Origin
X Position
0.0
Origin
(Length)
3
After determining the origin, press the
key.
• The printing origin is changed.
Changing the printing origin
When media is automatically detected, the printing start
point (origin) is set at the position shown in the figure
below.
You can change the printing origin according to your
needs.
Printing
origin
.
to set the
Y Position
0.0
Origin
(Width)
Fabric
retainer
10mm
Advertisement
Table of Contents
