Table of Contents
Advertisement
Chapter 5 Troubleshooting
Ink tank warning appears
If an ink tank trouble is detected, a warning message
appears.
None of printing, cleaning and all the other operations that
use ink is available.
If
an
abnormality
occurs,
procedures:
• Check the ink amount in the ink tank and if the ink amount
is not enough, add ink.
• Once ink tank trouble is displayed, do not leave
the ink bottle without replacing it for a long time;
otherwise, the machine will lose the nozzle
missing prevention function.
If nozzles are clogged, the machine must be
repaired by MIMAKI's service engineer.
Displaying the description of ink bottle
trouble
The contents of ink bottle error are confirmable by the
following operations.
1
Press the
Sb310-4
1.
90% EXPIRATION 2MONTH
M
80% No Error
2.
C
80% No Error
3.
Y
4.
80% No Error
K
In case of ink leakage
In case of ink leakage, please turn off the main power
switch, unplug the power plug, and contact our service
office or distributor.
If an error related to the Sub Tank
occurs (Error 618 to 61b)
The Error 618 to 61b are related to the sub tank.
Execute following procedures when an error about sub
tank occurs, or when the nozzle is not unclogged after
cleaning.
1
Press the
2
Press
and press the
• Maintenance menu appears.
3
Press
press the
4
Press
• Discharge the ink in the sub tank, and charge ink
into the tank.
5-4
perform
the
following
key in Local.
(MENU) in Local.
to select "Maintenance"
key.
to select "Sub Tank", and
key.
key.
When media heaves up at feeding
We call the status of heaving media at feeding "cockling".
When media cockling occurs, check the following items:
Note/ checking
items
Checking media
(1) Check that the media is set
straight and reset it.
set status
(1) For roll media, feed the media by
about tens of centimeters to one
Media feeding
meter.
(2) For leaf media, press [][]
and perform feed/ back feed.
Do not leave the
(1) Do not start printing with the
media cockled because it may
media in the
cause media jam.
heater warming
status
Heighten the
(1) For the thick media, make the
head gap higher before printing.
head
Measures
Advertisement
Table of Contents
