Table of Contents
Advertisement
Chapter 1 Before Use
• Material that bends when installed on the feeding device
because the paper core being used is not strong enough
• When using media other than the above, make
sure you perform a test print.
• Check the print results to determine if the media is
suitable.
Requirements for printing on fabric
Item
Requirements
±5 mm or less
Uneven width
from one side to
the other
Curls when
No one-direction
spread out
curls
Height of wrinkles
(slack) when
1 mm or less
spread out on a
flat surface
±15 mm, fabric
Differences in the
(with a width of
roll edges
500 mm or less)
±2 mm
Internal roll
3 inches
diameter
Roll curve of 5
mm or less when
Paper core
set
strength
(Paper core
thickness of 5 mm
or more)
Paper core
extending beyond
20 mm or more
the edge of the
fabric
Tape in 3 points or
Fixing the paper
less or secure
core
with a weak
adhesive
Roll outside
Φ300 mm or less
diameter
Roll weight
60 kg or less
Involuted/
Printing surface
Revoluted
N/A
Winding wrinkles None
1-14
About the emergency
switch
Please press the emergency switch when you feel danger
such as hand or hair is caught or the like during operating
this machine.
The position of the emergency switch
Notes
Emergency switch is attached to the position shown in the
following figure.
If you feel the danger, please press near switch.
Advertisement
Table of Contents
