Table of Contents
Advertisement
6
Check the correction pattern and enter a
correction value.
• A screen for entering the correction value
appears.
• Enter a correction value in "+":
The boundary between the two bands is widened.
• Enter a correction value in "-":
The boundary between the two bands is
narrowed.
• When you change the correction value by "25",
the width of the boundary changes by about 0.1
mm.
7
Press
key.
• Print a correction pattern again and check it.
• When media correction is needed, perform the
operation in Step 6 to make correction.
8
Press
the setting.
Correcting Media-feeding during
Printing
A media-feeding rate can be corrected even in the remote
mode or when image data is printed.
1
Press the
2
Press
to enter a corrected
feeding rate.
• Corrected feeding rate: -9999 to 9999
• The value entered here is reflected in the corrected
feeding rate soon.
3
Press
key.
• The changed value is registered.
key several times to end
(ADJUST) in the Remote.
If the Positions of Dots Shift...
When the condition for printing (Distance of the platen and
the head /media thickness/media type/etc.) has been
changed, perform the following operation to correct the
ink drop position for bidirectional (Bi) printing and obtain
the proper printing result.
Example of a Printed Pattern
Output
direction
The dots at the fourth position
counted from the zero position in
the positive direction form a
straight line.
In this case, the dot position
correction value is 4.0.
1
Setting a Media (
• In order to print a pattern, a media that is 500 mm
wide at least is necessary.
2
Press the
Local.
3
Press
to select SETUP 1 to 4, and
press
key.
• Setup menu will be displayed.
4
Press
to select
"DropPos.Correct" , and press the
key.
5
Press
key.
• Printing of the Drop position correct printed
pattern will start.
• Multiple test patterns are printed. (The printed
patterns are called Pattern 1, Pattern 2 in the
order of printing.)
6
Press
to enter the correction
value for pattern 1, and press the
key.
• Corrected feeding rate: -40 to 40
• Check the test patterns. The position where an
outward feeding line and a return feeding line
become one straight line is the correction value.
• When the correction value in not between -40 and
40, adjust the height of the printing heads and
then perform the operations in Step 2 and later.
7
In the same way as step 6, enter the
correction value for patterns 2 to 5, and
press the
8
Press
the setting.
Chapter 3 Setup
P.2-4)
key in
(MENU)
key.
key several times to end
3
2
2
3-7
Advertisement
Table of Contents
