Table of Contents
Advertisement
Setting of Media Cor-
rection
Correct the media feed amount to match the type of
media you are using.
If the correction value is not appropriate, stripes may
appear on the printed image, thus resulting in a poor
printing.
• Be sure to perform feed correction each time
before printing. The media feed amount may vary,
depending on the remaining amount of the roll
media.
• If use by setting the media to Narrow roll holder,
rewind the roll media by hand and set without
slack.
There may not be accurate to correct the feed
amount.
• On completion of [MEDIA COMP.] during use of a
roll media, the media returns to the printing origin.
When a media is set on the narrow roll holder,
slack occurs in the roll media on the backside of
this machine.
Before printing, take up the slack in the roll media
by hand; a loose roll media can result in an inferior
image quality.
• When printing with a take-up device, set the media
first and then perform media correction.
• When printing without using the take-up device,
feed the media until the media reaches the floor
before performing the correction. Otherwise, the
feed amount may not be adjusted normally.
Setting of Media Correction
A pattern for media correction is printed and a media-
feeding rate is corrected.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the two bands.
Second band
First band
1
Setting a Media (
2
Press the
(ADJUST) in LOCAL.
• Adjust menu appears.
3
Press
key.
P.2-4)
key and press
Chapter 2 Basic Operation
4
Press the
correction pattern.
5
Check the correction pattern and enter a
correction value.
• A screen for entering the correction value
appears.
• Enter a correction value in "+":
The boundary between the two bands is widened.
• Enter a correction value in "-":
The boundary between the two bands is
narrowed.
• When you change the correction value by "30",
the width of the boundary changes by about 0.1
mm.
6
Press
the setting.
• You can select "Feed Comp." by using the
[FUNC1](MENU) in the Local without pressing the
[FUNC2] (ADJUST) key. (
Correcting Media-feeding during
Printing
A media-feeding rate can be corrected even in the remote
mode or when image data is printed.
1
Press the
Remote
Feed Comp.
Current Value
Changed Value
2
Press
to enter a corrected
feeding rate.
• Corrected feeding rate: -9999 to 9999
• The value entered here is reflected in the
corrected feeding rate soon.
3
Press
key.
• The changed value is registered.
• When you press the [ENTER] key instead of the
[END/POWER] key, the value entered here will be
invalid.
4
Press
the setting.
key to print the
key several times to end
P.3-6)
(ADJUST) in the Remote.
Current
0
correction
10
value
key several times to end
2
2
2
2
2-35
Advertisement
Table of Contents
