Table of Contents
Advertisement
Chapter 2 Basic Operation
Setting a Media
This machine can be used with a roll media and leaf
media.
For usable medias, refer to P.1-13 "Usable sizes of
media".
Checking the Spacers
Attach the type (you can attach 3 types) of spacer you
need to use according to the media and print method
being used.
About the different spacers
You can attach 3 types of spacers to the machine.
Ink receiving spacer (Large/Small)
Fabric edge spacer
Adjusting spacer
When printing on fabric (When not using
overprint)
Use the ink receiving spacer.
When printing on fabric (When using overprint)
Use the ink receiving spacer and the fabric edge
spacer.
2-4
When printing on cloth (when a print quality on
a thick media is unstable)
Please use an adjustment spacer after having tested
by drawing data whether the ink does not bleed to the
back of the cloth.
If printing on a media of which the ink
bleeds to the back, bled ink attaches to
other points. As this causes that the
printer becomes dirty and a picture quality
turns worse, do not use such a media.
When correcting drop position
Use the adjusting spacer.
Installing and removing the ink receiving
spacer and the fabric edge spacer
Make sure you install spacers to prevent media being
soiled by ink mist when printing and to apply the ink
correctly.
1
Apply fabric retainers on the left and right.
2
Installing the ink receiving spacer and the
fabric edge spacer.
• The ink receiving spacer is 250 mm (W) x 177 mm
(D).
Adjust the number of ink receiving spacers installed
according to the width of the image being printed.
Ink receiving spacer
Fabric edge spacer
Advertisement
Table of Contents
