Cleaning The Ink Head And The Area Around It - MIMAKI Tx500P-3200DS Operation Manual

Chapter 4 Maintenance
10
Suction the cleaning solution into a
syringe and squirt about three syringes
worth of solution into each cap.
11
Close the lower part of the right side front
cover, and press the
• After the idle absorbing operation has been
performed for 30 seconds, the screen returns to
step1.
4-14
Cleaning the Ink Head
and the Area around It
Because
mechanism, due care needs to be taken when it is
cleaned.
Using a clean stick, etc., rub off gelatinous ink or dust that
may stick to the lower part of the slider and the area
around the ink head. In doing so, never rub the nozzles of
the head.
• Clean stick
• Goggles
key.
1
2
3
4
the ink head employs
Tools required for cleaning
• Gloves
• Be sure to wear the attached goggles and gloves
when replacing the ink absorber. Otherwise, you
may get ink in your eyes.
• The ink contains organic solvent. If you get the ink
on your skin or in your eyes, wash it away with
plenty of water immediately.
Press the key and press
(MAINT) in LOCAL.
• The Maintenance menu appears.
Press , select [Carriage Out], and
press the key.
Press to select "Head Maint.",
and press the key.
• The carriage will move to the left end of this
machine.
Remove the lower part of the left side front
cover.
(1) Remove the screws (for two positions) of the
lower part of the left side front cover.
(2) Pull the lower part of the left side front cover
in front , lift it above, and remove the lower
part of the left side front cover.
• Remove the screws use the supplied screwdriver.
Lower part of the
left side front cover
a very precise
Screw