MIMAKI Tx500P-3200DS Operation Manual page 107

4
Remove the wiper.
• Pull out the wiper by holding the protrusions at its
both ends.
5
Clean the wiper and bracket.
• Wipe off the ink sticking to the wiper and bracket
with a clean stick dipped in cleaning solution for
maintenance.
Wipe off so that cleaning solution for maintenance
will not remain.
Wiper
6
Clean the wiper cleaner.
• Wipe off the ink sticking to the wiper and bracket
with a clean stick dipped in cleaning solution for
maintenance.
7
Clean the wiper ink pan.
• Water-based ink does not flow easily. Ink dries,
gets stuck, and accumulates. Use a rubber
spatula or the like to frequently push the ink that
piles up in the ink pan beneath the wiper towards
the waste route.
Projection
Bracket
wiper cleaner
8
Set the wiper at the original position.
• Insert the wiper by holding both ends of the wiper.
9
Clean the cap rubber and cap rubber
cover.
• Wipe off the ink sticking to the cap rubber and cap
rubber cover with a clean stick dipped in cleaning
solution for maintenance.
Wipe off so that cleaning solution for maintenance
will not remain.
Cap rubber
10
Close the lower part of the right side front
cover, and press the
• After its initial operation, the machine returns to
step1.
Performing the Station without
[FUNC2] (MAINT)
You can select Station by using the [FUNC1] (MENU) in
the Local without pressing the [FUNC2] (MAINT).
(1) Press the [FUNC1] (MENU) in Local.
(2) Press [][] to select "Maintenance", and press the
[ENTER] key.
(3) Press [][] to select "Station", and press the
[ENTER] key.
• The Station menu appears. Then proceed to step 2.
Chapter 4 Maintenance
Cap rubber cover
key.
4-11
4
2