Set The Network; Setting Event Mail Function - MIMAKI TS500P-3200 Operation Manual

Set the network

You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at
Mimaki Engineering (http://eng.mimaki.co.jp/download/).
1
Press the
2
Press
and press the
3
Press the
4
Press
and press the
5
Press
press the
6
Press
Address" and press the
• The IP address currently used by this machine is
displayed.
• After connecting with the network, it takes time
until the IP address is determined.
If the IP address has not been determined,
"0.0.0.0" is displayed.
7
Press
Address" and press the
• The MAC address currently used by this machine
is displayed.
8
Press
press the
• Press [][] to set ON/ OFF.
• When it is ON, the IP address given by the DHCP
server is used.
9
Press
press the
• Press """" to set ON/ OFF.
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press
and press the
• Both of DHCP and AutoIP is OFF, you can set IP
Address/ Default Gateway/ DNS Address/ Sub
Net Mask. For other than above, proceed to the
Step 13.
11
Press
values.
12
Press
3-22
(MENU) in Local.
to select "Machine Setup"
key.
(>>) twice.
to select "Network & Mail"
key.
to select "Network" and
key.
to select "Check IP
key.
to select "Check MAC
key.
to select "DHCP" and
key.
to select "AutoIP" and
key.
to select the set values
key.
to select the set
to confirm the value.
13
Press the
end the setting.
• To reflect network setting, once turn off the power
supply and then turn it on again.

Setting event mail function

Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform event mail function setting with
"Network Configurator", the tool to perform network
setting of Mimaki's product. To download the Network
Configurator, check " Driver / Utility" on the download
page at Mimaki Engineering (http://eng.mimaki.co.jp/
download/).
Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.
Enable the event mail function
1
Press the
2
Press to select "Machine Setup"
and press the
3
Press the
4
Press to select "Network & Mail"
and press the
5
Press to select "Event Mail" and
press the
6
Press to select "Mail Deliverry"
and press the
7
Press to select "ON" and press
the key.
8
Press the
end the setting.
key several times to
(MENU) in Local.
key.
(>>) twice.
key.
key.
key.
key several times to