Table of Contents
Advertisement
8
Remove the ink tank of the selected slot
and press the
(1) Press the protrusion on the lid of the ink tank
and remove the lid.
(2) Tilt the ink tank to the front and remove.
• Please be careful not to bend the tube by
tilting a tank too far.
(3) Wipe the tube that is attached to the lid with
the waste cloth etc., put the tube on the
outside of the balance.
9
Place the 1kg weight on the dish of the
balance of selected slot and press the
key.
• Process the correction.
• Please put the weight in the center of the dish of
the balance.
If you put weight on the edge of the dish, it will
cause to increase the error of the remaining
amount detection.
• During the correction process, please do not give
vibration to the external ink supply unit. There is a
possibility to fail the correction process.
• When the correction process fails, "Failed" will be
shown on the display. Press the [ENTER] or [END]
key, and change the position or the load of the
weight.
key.
Weight
10
When the correction processing is finished
successfully, remove all the weights on the
dish of the balance and press the
key.
• Perform the correction processing without the
weight on the balance.
• During the correction process, please do not give
vibration to the external ink supply unit. There is a
possibility to fail the correction process.
• When the correction process fails, "Failed" will be
shown on the display. Press the [ENTER] or [END]
key to clear the error display and press again the
[ENTER] key. It will resume the correction
processing.
11
When the correction processing is finished
successfully, set the ink tank that was
removed in step 8 and press the
key.
Correct by the correction method
"Adjust Zero Pos."
1
Press the
(MENU) in LOCAL.
2
Press
to select "Maintenance"
and press the
3
Press the
(>>) .
4
Press
to select "Tank
Calibration", and press the
5
Press
to select "Adjust Zero
Pos." and press the
6
Press
to select an ink tank (slot 1
To 8) to be corrected, and press the
key.
7
Remove the ink tank of the selected slot
and press the
• Perform the correction processing without the
weight on the balance.
• During the correction process, please do not give
vibration to the external ink supply unit. There is a
possibility to fail the correction process.
• When the correction process fails, "Failed" will be
shown on the display. Press the [ENTER] or [END]
key to clear the error display and press again the
[ENTER] key. It will resume the correction
processing.
8
When the correction processing is finished
successfully, set the ink tank that was
removed in step 7 and press the
key.
Chapter 4 Maintenance
key.
key.
key.
key.
4-29
4
2
Advertisement
Table of Contents
