MIMAKI Tx500P-3200DS Operation Manual page 52

Chapter 2 Basic Operation
Status Time
2-22
HEATER SETTING 1
[Temperature Indication]
Changes the displayed
temperature units.
[Temperature Setting]
Sets the temperature.
[Timer Setting]
Configures the timer or clears the
filter time.
[External Setting]
Sets the external input and output.
[Log Clear]
Clears the log.
HEATER SETTING 2
[Backlight Setting]
Backlight Setting
[Version]
Displays the version.
Changes the displayed temperature units.
[Celsius]
Displays the temperature in Celsius.
[Fehrenheit]
Displays the temperature in Fahrenheit.
Temperature Setting
[Fixing Heater Temperature]
Displays the temperature set for color
fixation.
* Displays the temperature when the heater
is on in the LOCAL mode, or when the
printer sends the command to turn the
heater on.
[STAND-BY Temperature]
Displays the temperature set for the
standby mode.
* The transition to the standby temperature
is available only with the printer command.
Timer Setting
[Automatic Heater Off Timer]
Displays the time required for the status
to change from "Ready" to "OFF".
* The timer is disabled during printing.
[Filter Cleaning Timer]
Displays the time elapsed after the filter
is cleaned.
[CLR]
Clears the time elapsed after the filter is
cleaned.
External setting
[External Input]
The heater is switched off after the signal
input.
[Extermal Output]
Activates the non-voltage output mode
when the heater is on.
Backlight setting
[Backlight off function]
Backlight ON / OFF at heater OFF
[OFF Timer]
Time to turn off at Enable setting (minutes)
Displays the version.
[PLC Version]
Displays the version of the main PLC unit.
[Touchpanel Version]
Displays the touch panel version.
[Filter Replace Timer]
Displays the time elapsed after the filter
is replaced.
[CLR]
Clears the time elapsed after the filter is
replaced.