Table of Contents
Advertisement
Chapter 4 Maintenance
9
Press
end the setting.
• Up to 10 nozzles can be registered per 1 nozzle
line.
• Even if you use this function, time required for
drawing does not change.
• The nozzle recovery may not reflected if printing is
performed under the following conditions:
4-colors ink set
Resolution
540 x 360
720 x 720
720 x 1080
6-colors ink set
Resolution
540 x 360
540 x 540
720 x 1080
Check the print condition for which
nozzle recovery cannot be performed
Depending on the nozzle registered, there is the mode not
reflected by "RECOVERY". Check the unrecoverable print
conditions with the check function.
• If there are many registered nozzles, it takes time
to display the check result.
1
Press the
2
Press
and press the
• Maintenance menu appears.
3
Press
Recovery", and press the
4
Press
press the
• The mode for which nozzle recovery is invalid is
displayed.
• If there is no mode for which nozzle recovery is
invalid, "NONE" is displayed.
5
Press
the setting.
4-18
key several times to
Pass
Scan speed
2 pass
High speed
4 pass
High speed
6 pass
High speed
Pass
Scan speed
4 pass
High speed
6 pass
High speed
12 pass
High speed
(MENU) in Local.
to select "Maintenance"
key.
to select "Nozzle
key.
to select "Check", and
key.
key several times to end
Reset the set value
1
Press the
(MENU) in Local.
2
Press
to select "Maintenance"
and press the
• Maintenance menu appears.
3
Press
to select "Nozzle
Recovery", and press the
4
Press
to select "Setup Reset",
and press the
5
Press
to select desired head(s)
(Head Line 1 to 3), and press the
key.
6
Press
and
to select the Nozzle line that needs to be
reset, and press the
• A reset confirmation message appears.
7
Press
key.
8
Press
key several times to end
the setting.
key.
key.
key.
(<<)
(>>)
key.
Advertisement
Table of Contents
