Table of Contents
Advertisement
Chapter 2 Basic Operation
1
Set both of "Setting Feeding unit" and
"Setting Take-up unit" of the machine
setting to "ON".(
2
Slowly lower the tension bar at the rear of
the machine
• Unlock the tension-bar, and then lower it.
Tension-bar
lock plate
3
Remove the roll shaft on the feeding
device at the back of this machine.
(1) Lower the lever that is attached to the right
and left of the cover of media feeding device
and release the lock.
(2) Open the covers.
(3) Remove the roll shaft.
• When carrying the roll shaft, be sure to grip
handles on the both ends. Gripping other parts,
your hand may get stuck in the printer.
• To prevent dust, set paper core or media to the
roll shaft on the table or sheet. Dust on the paper
core or the media may cause defective print.
4
Remove the roll holders.
• The roll holders are on both for the right and left of
the roll holder. Remove both with the procedures
below:
(1) Loosen screws (1 each on the right and left)
with supplied ratchet handle.
(2) Remove the holders.
2-10
P.3-18,P.3-19)
Tension-bar
Ratchet handle
Roll holder
5
Set a media on the roll shaft.
(1) Put the roll shaft through a paper core.
• Need to adjust the position of the paper core
to come in the middle of the roll shaft. Set the
media so as to align the scale of media set
label and the center position of the paper
core .
(2) Push both sides of the roll holders into the
paper core, and tighten screws with supplied
ratchet handle to secure.
• Please be careful not to pinch your hand between
the paper tube and the roll shaft.
6
Put the roll shaft with the media on the
feeding device.
(1) Fitting the A part of the roll shaft to the B part
bearing of the machine, put it on.
B part
A part
• Carefully set A part so as not to hit near frame.
Scratches can cause malfunction.
(2) Close the right cover.
(3) Slide the lever to lock.
• Put the shaft on gently, not roughly.
Advertisement
Table of Contents
