Table of Contents
Advertisement
Chapter 2 Basic Operation
34
Holding the media on both sides, lift it
carefully.
35
Open the hood cover for the coloring
heater.
2-16
Entering the media width and
remaining amount
When you set "Media remaining amount display" and
"Media detection/ width" to "ON" and "MANUAL"(
19, P.3-20), input screen for the media width and the
remaining amount is displayed after detecting the media
thickness.
1
Display the screen for entering media
width.
• When you set the to "AUTO" in the "Setting the
Media Detect/Width" of the machine setting, this
screen is not displayed. (
• When the tension bar of media take-up device
locates at a high position, the following message is
displayed.
Press [▼] to take the media out.
Take-up Tension bar is
巻取テンションバー高い
high. Please feed media
搬送方向スイッチを確認し
until OK is displayed.
OKが表示されるまで
フィードしてください
When Tension bar goes down to a certain height,
the screen is switched into the following.
Press [ENTER] key to switch into the next screen.
Take-up Tension bar is OK
巻取テンションバーOK
2
Press
to enter the media width.
3
Press
key.
4
Display the screen for entering media
remaining amount.
• When you set "Setting the Display of Media
Remain" of the machine setting to "OFF", this
screen is not displayed. (
5
Press
to enter the media
remaining amount.
6
Press
key.
P.3-
P.3-20)
[ENT]
P.3-19)
Advertisement
Table of Contents
