Table of Contents
Advertisement
Printing Data
Starting a Printing Operation
• When the same data is printed, the color may
differ if print conditions are changed, including the
resolution, pass, scanning speed, and printing
direction. Check the effects before printing.
1
Setting a Media (
2
Checking the Heater Temperature
3
Press the
(REMOTE) key in LOCAL.
• If the heater temperature has not reached the
setting
value,
"TEMPERATURE CONTROL" is displayed. Even
if it has not reached, you can move to Remote
when pressing the [ENTER] key.
• The screen changes to Remote, and data can be
received from the PC.
P.2-4)
the
warning
message
Chapter 2 Basic Operation
4
Transmit data to be printed from the PC.
• For the method of data transmission, see the
instruction manual for the output software.
Resolution
Data type
VD : Variable data / ND : Normal data
REMOTE
C0.1m
540x360
VD
4/ B / x1 / W1 / ALL / R
0.0m
Nozzle recovery information
R: Nozzle recovery is performed.
Select head
Waveform selection
W1 : WF1/ W2 : WF2
Scan speed
x1 : Standard speed/ x2 : Double speed
Scan direction
U :Unidirectional / B : Bidirectional
Number of passes
1
*
This is indicated when turning on the automatic
cleaning and the RIP separation.
If executing the manual cleaning when this is in a state
displaying, there is a blank in the timing of the RIP
end.
5
Start printing.
• The printing speed may change, depending on
the width of the set media or the position of the
print origin even when the same data is printed.
This is because of a difference in resolution.
Stopping a Printing Operation
Perform the following operation when stopping a printing
operation halfway.
1
Press the
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.
Deleting Received Data (Data Clear)
When you want to stop printing, delete the already
received data.
1
Press the
(DATA CLEAR) in LOCAL.
2
Press
key.
• The received data is erased then it returns to the
Local.
The length before
starting the automatic
*1
cleaning
The length of
media printed
(LOCAL) during printing.
key, and press
2-37
2
2
2
2
Advertisement
Table of Contents
