Installing The Antistatic Fabric - MIMAKI Tx500P-3200DS Operation Manual

Standards for installing the ink receiving
spacer and the fabric edge spacer
• Makes sure that the width of the ink receiving
spacer and the fabric edge spacer combined is not
less than the width of the image being printed.
• Adjust the number of spacers so that there is a gap
of at least 10 mm to the edge of the image on the
left and right.
• Move the edge of the fabric edge spacer as close
as possible to the edge of the media.
Fabric edge spacer
Amount of overprint:
less than 20 mm
Media
10mm or more
Increase the gap in the ink receiving spacer
according to the margins in the media, and
adjust so that the gap is equal.

Installing the Antistatic Fabric

Some types of media have a tendency to generate static
electricity.
We recommend attaching the antistatic fabric to prevent a
decline in print quality caused by static electricity.
Note that the antistatic fabric does not
completely eliminate static electricity.
• The antistatic fabric reduces the influence of static
electricity. Therefore, attaching the antistatic fabric
does not completely prevent any decline in print
quality caused by static electricity.
• You can also reduce the generation of static
electricity by using humidifiers in combination with
the antistatic fabric.
Amount of overprint:
less than 20 mm
Fabric
Ink receiving
edge
spacer
spacer
Print width
10mm or more
Chapter 2 Basic Operation
Installation position of the antistatic
fabric
Attach antistatic
fabric to the front
of the vertical
section of the
pinch rollers.
2-5
2
2
2
2